PHOTOSHOP LAB REPORT :: essays research papers

1.) Objective of the labThe objective of this lab was to benefit a halftone negative of a small clipart. 2.) Facilities, supplies and equipment usedWe did this in the photo lab and in the dark room. To complete this lab we inevitable to have a working knowledge of the camera, developer, fix and a loop.3.) Techniques activeTo make admit of a clipart several steps must be taken. First is to turn the copy posting to be parallel to the floor. hence the glass see must be unlocked and lifted. The art is then officed in the center of the board next to a blue-eyed(a) scale. After shutting and locking the glass front the copy board is then turned to be upright facing the shutter of the camera. The aperture should be set at an F- wear of 22 at %100. The next step takes place in the dark room on the other side of the handle camera. You must position the miasmic plate to be locked in front of the shutter. You then inspire the test button or switch to nail the alignment of the art on the copy board. When aligned you open the transparent plate and use the vacuum to hold the film in position on the solid plate. You then close the solid plate and press the button that controls the timer for the shutter. This exposes the film to the light from the clipart and the antique scale. When the shutter closes you move back the film by turning off the vacuum. Then place the film in the developer until you can see the level 4 on the gray scale. This is the desired development of the film. When thither you place the film in the stop solution. After a minute or so in there you place the film in the fix. This removes all the remaining silver from the film.